Hi @DeGrazendeSlak, good spots
The FabCore is plug and play, no assembly required. its smaller than the FabKit and does not have a motorised moving bed. Its also slightly cheaper.
Integrated alignment laser is standard as its installed in the factory so we can use it to quickly align the mirrors, also useful for aligning your work
The FabCore is quite a lot smaller than the FabKit, hence its smaller cutting area but also smaller laser tube.
The laser tube design is the same as the FabKit just 55 instead of 80mm
For the FabKits tube the min tigger point is about 0.7/0.8%. This is set in the firmware, so anything above 0% will fire in lightburn.
The FabKits 40w co2 has a low pressure in the tube, this allows us to ignite the tube at lower powers making for cleaner cuts and engraves at the lower end of the power range.
The Max power of the FabKits tube is limited to 70/80% we do this to ensure a long lifespan.